Every damper is located, drop tested, photographed and reported. If a damper fails, we can quote and carry out the remedial works as a separate job.
Hands-on damper testing and compliance work in live commercial, data centre and public-sector buildings.
CITB/AEME damper qualification, CSCS, IPAF and PASMA.
One call to book. We come to you, test and report, and quote for any remedials.
We test fire dampers and carry out the remedial works they need.
Planned testing for facilities managers, landlords and managing agents. We work through the building damper by damper and give you a record you can show a fire risk assessor.
Booked separately from testing and quoted from the defects in your report.
Extract system cleaning and air hygiene assessments, passive fire protection support, and planned maintenance schedules for sites with several buildings. Ask if you need something that isn’t listed above.
The same five steps on every site, so you always know what you’re getting.
We find each damper against your drawings or asset list. If you don’t have one, we build it.
Frame type, orientation, fixings, breakaway joints, fire barrier and whether the damper can be reached.
The fusible link is released by hand and we check the curtain closes fully and locks.
Cleaned if needed and reset open, ready for the next test.
Photos, results and recommended actions for every unit, sent digitally.
Your fire risk assessor, insurer or building control officer can ask for proof that dampers were tested. This is what we hand over.
Every visit is carried out by a qualified, carded engineer.
Based in East London, working across every borough and the surrounding counties. If you manage buildings in more than one place, we can test them under one contract.
BS 9999:2017 says at least once a year, and more often where dampers sit in dusty or polluted air. Every report includes a recommended retest date.
Dampers need to be accessible to be tested properly. If one is hidden behind ceilings or ductwork, we’ll log it as a limitation in the report and quote for an access panel or ceiling hatch.
Every failed damper is logged in your report with the work needed. We can then quote for the remedials as a separate job, from fusible links and fixings to replacement dampers.
Standards require breakaway joints, so the connected ductwork can fall away in a fire without pulling the damper out of the wall. Tek screws don’t do that. We replace them with aluminium rivets.
We keep disruption low and agree access and working hours with your site team beforehand. Out-of-hours visits can be arranged.
Tell us about the building and roughly how many dampers there are. If you don’t know, say so and we’ll work it out.